Thermo Scientific TRACE 1600 Hardware Manual page 477

Thermo Scientific
There is not a precise point of connection of the kit on the carrier gas line. You connect the kit
on the carrier gas line where it is easier for you adjusting the carrier pressure. For example you
could connect the kit near the carrier gas cylinder, or near the GC.
Figure 440 shows the pneumatic diagram for connecting the kit.
Figure 440. Schematic Diagram
The kit consists of the following parts:
• Pressure regulator and manometer
• Tee union (in case you connect both the front and back carrier gas)
• Fittings
• Bracket (in case you hook the kit on the back cover of the GC)
• Copper tubing (3-m long for connecting the kit to the carrier gas line)
Figure 441 shows the connection to the front or back carrier gas inlet on the GC.
8
Installing the Pressure Regulator Kit for Gas Sampling Valve
TRACE 1600/1610 Hardware Manual
Installing Optional Kits
Pressure Regulator
Manometer
445