Thermo Scientific TRACE 1600 Hardware Manual page 536

9
Adding Modules
Adding a PDD Module
504 TRACE 1600/1610 Hardware Manual
Figure 508. Pulses Cable Connection (3)
d. Connect the cable between the pulse generator and the pulse generator control on the
PDD module. See
Figure 509. Pulses Cable Connection (4)
WARNING If for any reasons it is necessary to disconnect the cables from the pulse
generator, the safety covers must be removed proceeding in the reverse order in which they
was installed. Before starting, make sure that the GC is powered Off.
Figure 509.
Pulses Generator Control
Connector
Thermo Scientific