Table of Contents
Advertisement
Connecting the AI/AS 1610 in Standard Configuration
Configuration
Thermo Scientific
To connect a front or back sampling unit to the GC in standard configuration
1. Using the cable provided, connect the Mini Delta connector from the AI 1610 sampler to
the Mini Delta connector on the back of the Trace 1600 Series GC.
Figure 37. Connections Between Front or Back Autosampler and GC
Autosampler back panel
To FRONT AS
or BACK AS
connector on GC
GC back panel
This section provides instructions to connect two AI/AS 1610 sampling units to a Trace 1600
Series GC. See
Figure 38
To connect two sampling units to a GC in Gemini configuration
1. On the front autosampler use the provided cable to connect the COM 24 V connector to
the FRONT AS connector on the rear panel of the GC.
2. On the back autosampler use the provided cable to connect the COM 24 V connector to
the BACK AS connector on the rear panel of the GC.
for connector locations.
1
Installing the Autosampler
TRACE 1600/1610 Hardware Manual
Installation
33
Hide quick links:
Advertisement
Table of Contents
