Thermo Scientific TRACE 1600 Hardware Manual page 561

Thermo Scientific
Figure 539. AOI Installation (1)
b. Carefully place the Analog Output Interface into the left or right housing until the
hexagonal screws couple with the slots on the floor of the GC. See
Figure 540. AOI Installation (2)
c. Finger-tighten the hexagonal screws slightly, or use a 10 mm wrench.
Note Always keep the hexagonal screws in their place. This allows you an easier
removal of the auxiliary module when necessary.
9
Adding Modules
Adding an Analog Output Interface
Hexagonal Screws
Figure 540.
Slots
TRACE 1600/1610 Hardware Manual 529