Thermo Scientific TRACE 1600 Hardware Manual page 385

Thermo Scientific
b. Loosen the retaining nut from the injector fitting on the upper interior wall of the
GC oven.
c. Remove the analytical column with its nut and ferrule from the bottom of the
injector.
6. Put the autosampler away if present.
7. Remove the SSL/SSLBKF injector module from its seat.
a. Open the module flap cover.
b. Using a T20 Torxhead screwdriver, unscrew the three captive fixing screws.
c. Throw upward the module from its seat of the injector housing. Place the
SSL/SSLBKF module on a clean surface.
WARNING Make sure the O-ring remains into its seat on the gas connection.
Do not install the module if the O-ring is missing.
8. Replace the module flap cover with the one's provided. See
Figure 332. Module Flap Cover for Purge & Trap
9. Reinstall the injector module into the main frame.
a. Open the module flap cover.
Installing the Purge & Trap Adapter Kit on the SSL/SSLBKF Injector
O-ring
Figure
Module Flap Cover
TRACE 1600/1610 Hardware Manual
8
Installing Optional Kits
332.
353