Thermo Scientific TRACE 1600 Hardware Manual page 545

Thermo Scientific
Figure 518. Housing Cover Removal
a. Using a T20 Torxhead screwdriver, unscrew and remove the left or right housing
cover screws, then remove the cover from the housing.
2. Install the GDI electrical interface into the housing
a. Loosen the two hexagonal screws under the module. See
Figure 519. GDI Module Installation (1)
b. Carefully place the GDI electrical interface into the left or right housing. Guide the
detector cable into the electronic compartment of the GC, next push the module
until the hexagonal screws couple with the slots on the floor of the GC.
See Figure 520.
9
Adding Modules
Adding a Generic Detector Interface
Left/Right Housing Covers
Figure 519.
Hexagonal Screws
TRACE 1600/1610 Hardware Manual
Left Cover
Screws
Right Cover
Screws
513