Thermo Scientific
b. Place the module into the left or right housing until the hexagonal screws couple the
slots on the floor of the GC. See
Figure 479. Module Installation (2)
c. Finger-tighten the hexagonal screws slightly, or using a 10-mm wrench.
Note Always keep the hexagonal screws in their place. This allows you an easier
removal of the auxiliary module when necessary.
The result of the installation is shown in
Adding an Aux Temperature/Cryo Module
Figure
479.
Figure
480.
TRACE 1600/1610 Hardware Manual
9
Adding Modules
Slots
481