ABB IRB 910INV Product Manual page 713

3
4
Removing the base
1
2
3
Product manual - IRB 910INV
3HAC068055-001 Revision: K
Action
Remove the screws and washers.
Remove the motor and the timing belt.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 118.
Remove the screws and washers.
© Copyright 2019-2022 ABB. All rights reserved.
5.8.1 Replacing the axis-1 gear unit sub-assembly
Note
xx1800002870
Note
xx1800002851
5 Repair
Continued
Continues on next page
713