ABB IRB 910INV Product Manual page 423

Hide thumbs Also See for IRB 910INV:

Table of Contents

Concluding procedure

Product manual - IRB 910INV

3HAC068055-001 Revision: K

For robots with protection class IP54 (option 3350-

For robots with protection type Clean Room (op-

tion 3351-1)

Pull the upper end of the bellow to the outer arm.

For robots with protection class IP54 (option 3350-

Hold the bellow for a little while until it's attached

to the housing.

For robots with protection class IP54 (option 3350-

For robots with protection type Clean Room (op-

tion 3351-1)

Secure them with the clamp.

The opening part of the clamp should be in the

opposite position to the gap on the bellow gasket.

For robots with protection type Clean Room:

Seal and paint the joints that have been opened.

Cut the paint or surface on the robot before

replacing parts on page 118

After all repair work, wipe the Clean Room robot

free from particles with spirit on a lint free cloth.

5.6.2 Replacing the bellows

xx1900001613

Tightening torque: 0.6 Nm ±10%

xx1900001611

xx1900001625

Continues on next page

Troubleshooting