ABB IRB 910INV Product Manual page 437

Hide thumbs Also See for IRB 910INV:

Table of Contents

Product manual - IRB 910INV

3HAC068055-001 Revision: K

5.6.3 Replacing the pulley on the ball screw upper position

Refit the mechanical stopper to the ball screw at

1 mm position to the upper of the ball screw.

For robots with protection class IP54 (option 3350-

For robots with protection type Clean Room (op-

tion 3351-1)

For IRB 910INV-3/0.35, refit the mechanical stop-

per to the ball screw at 7 mm position to the upper

of the ball screw.

For IRB 910INV-6/0.55, refit the mechanical stop-

per to the ball screw at 2 mm position to the upper

of the ball screw.

Hold the ball screw to prevent it from dropping.

Or the ball screw may be destroyed.

If the ball screw nut or ball screw spline nut go

out of the screw shaft, the ball screw is destroyed.

Be careful when you do any work that may cause

xx1800002859

For robots with protection class

IP30 (option 3350-300)

xx1900002012

For robots with protection class

IP54 (option 3350-540)

For robots with protection type

Clean Room (option 3351-1)

For IRB 910INV-3/0.35

xx1900001639

For IRB 910INV-6/0.55

Continues on next page

Troubleshooting