ABB IRB 910INV Product Manual page 161

Refitting the internal harness
Use these procedures to refit the internal harness.
Inserting the internal harness through the inner arm
1
2
3
Product manual - IRB 910INV
3HAC068055-001 Revision: K
Action
For robots with protection type Clean Room:
Clean the joints that have been opened and wipe
the parts free from particles with spirit on a lint
free. See Cut the paint or surface on the robot
before replacing parts on page 118
Note
After all repair work, wipe the Clean Room robot
free from particles with spirit on a lint free cloth.
Make sure that the robot is at zero position.
Insert the internal harness into the inner arm
through the sleeve of the axis-1 gearbox from the
base.
Tip
Wrap the connectors with the masking tape.
Tip
The air hoses should face the axis-1 motor.
CAUTION
Make sure that no cables or hoses are twisted or
strained. Reroute if necessary.
© Copyright 2019-2022 ABB. All rights reserved.
5.3.2 Replacing the internal harness
Note
xx1800002825
xx1800003412
Continues on next page
5 Repair
Continued
161