ABB IRB 910INV Product Manual page 267

7
8
9
10
Product manual - IRB 910INV
3HAC068055-001 Revision: K
Action
Use a handheld dynamometer hooking to the
special tool and pull the dynamometer to make
the tension falling in the allowed force range.
Note
During the measurement, make sure that all inter-
ferences that may affect the force are removed.
Pay attention to the force application direction.
Fasten the screws to the recommended tightening
torque.
Use a sonic tension meter to measure the timing
belt tension.
If the timing belt tension does not meet the require-
ment, loosen the motor screws and readjust.
© Copyright 2019-2022 ABB. All rights reserved.
5.4.2 Replacing the axis-1 timing belt
Note
Used belt: 70-80N
New belt:100-110N
xx1900000094
Tightening torque: 3 Nm ±10%
xx1800002871
Used belt: 250-305Hz
New belt:296-378Hz
Continues on next page
5 Repair
Continued
267