5 Repair
5.8.2 Replacing the axis-2 gear unit sub-assembly
Continued
4
Separating the axis-2 gear unit sub-assembly from the outer arm
1
2
3
Continues on next page
750
Action
Remove the outer arm with the axis-2 gear unit
assembly from the inner arm.
Tip
Move the internal harness out of the way.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See
Cut the paint or surface on the robot before
replacing parts on page
118.
Remove the screws and washers.
© Copyright 2019-2022 ABB. All rights reserved.
Note
xx1800003383
Note
xx1800003384
Product manual - IRB 910INV
3HAC068055-001 Revision: K