ABB IRB 910INV Product Manual page 763

3
4
5
6
7
Product manual - IRB 910INV
3HAC068055-001 Revision: K
Action
Refit the bracket to the outer arm without screws.
Note
The harness are not visible due to the cleanness
requirements of the illustration. They are still ex-
isting inside the cable ferrule in the actual situ-
ation.
Insert the female head of the C1 cabling connector
to the bracket accordingly.
Tip
The mistake proofing measure has been applied
to the connectors, the connectors may be dam-
aged if excessive force is used.
For robots with C1 cabling
Reconnect the connector.
• R2.C1
Tip
See the number markings on the air hoses for
help to find the corresponding air hoses.
The air hoses with the same number connect to
the same L-shaped connector.
Note
The harness are not visible due to the cleanness
requirements of the illustration. They are still ex-
isting inside the cable ferrule in the actual situ-
ation.
For robots with C2 cabling
Reconnect the connector.
• R1.C2
Tip
See the number markings on the air hoses for
help to find the corresponding air hoses.
The air hoses with the same number connect to
the same L-shaped connector.
Secure the C2 cabling to the C2 bracket with the
cable straps.
© Copyright 2019-2022 ABB. All rights reserved.
5.8.2 Replacing the axis-2 gear unit sub-assembly
Note
xx1900000073
xx1900000071
xx1900000070
5 Repair
Continued
Continues on next page
763