Specifications; Important Safeguards; General Safeguards; Electrical Safeguards - GBC SureBind System One Instruction Manual

Specifications

Weight
Dimensions WxDxH
Power Requirements
Punch Capacity
Binding Capacity
Bind Cycle Time
Subject to technical changes without prior notice.

Important safeguards

WARNING: FOR YOUR PROTECTION, DO NOT
CONNECT THE EQUIPMENT TO ELECTRICAL
POWER OR ATTEMPT TO OPERATE IT UNTIL YOU
HAVE READ THESE INSTRUCTIONS COMPLETELY.
KEEP THESE INSTRUCTIONS IN A CONVENIENT
LOCATION FOR FUTURE REFERENCE.
WARNING: TO GUARD AGAINST INJURY, THE
FOLLOWING BASIC SAFETY PRECAUTIONS MUST
BE OBSERVED IN THE SET-UP AND USE OF THE
EQUIPMENT.

Electrical safeguards

WARNING: TO REDUCE RISK OF ELECTRICAL SHOCK
ALWAYS OBSERVE THE FOLLOWING SAFEGUARDS.
• The equipment must only be operated from the type of power
source indicated in these operating instructions and the serial
label located on the rear panel of the unit.
• The socket outlet should be located near the equipment and
should be easily accessible.
• The three-pronged grounding plug is a safety feature and
will only fit into an outlet. If you are unable to insert the plug
into an outlet contact a qualified electrician to have a suitable
outlet installed.
• Do not leave the power on overnight.
• Unplug the equipment before moving it or when it is not in use
for an extended period of time.
• Do not operate the unit with a damaged power supply cord
or plug, after it malfunctions, or after it has been damaged in
any manner.
• Do not let the power supply cord contact hot surfaces or
sharp objects.
• Do not over load electrical outlets beyond their capacity, as
this can result in fire or electrical shock.
4
SureBind System One
12.7kg
508 x 381 x 178mm
220-240 VAC / 50-60Hz
2
25 sheets 80g/m paper (3.5mm)
Up to 25mm thick x 355.6mm wide
8-10 seconds

General safeguards

• Use the equipment only for its intended purpose of punching
and binding documents.
• To avoid possible injury, never place fingers under the
pressure bar.
• Do not place the equipment on an unstable, cart, stand or
table. The binding system may fall, causing serious bodily
injury. Move the equipment and cart combination with care.
Quick stops, excessive force and uneven floor surfaces may
cause the binding system and cart to overturn. Before moving
the equipment, pull out the debris tray and discard pins and
paper to prevent them from spilling inside the machine.
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS
IMPORTANT TO ACCO BRANDS. IN THIS INSTRUCTION
MANUAL AND ON THE PRODUCT ARE IMPORTANT
SAFETY MESSAGES. READ THESE MESSAGES
CAREFULLY.
THE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY
MESSAGE IN THIS INSTRUCTION MANUAL. THIS SYMBOL
INDICATES A POTENTIAL PERSONAL SAFETY HAZARD
THAT COULD HURT YOU OR OTHERS AS WELL AS CAUSE
PRODUCT DAMAGE OR PROPERTY DAMAGE.
THE FOLLOWING WARNING IS FOUND ON THE BOTTOM
OF THE PRODUCT.
WARNING
Electrical shock hazard.
Do not open. No user
serviceable parts inside.
Refer servicing to qualified
service personnel.
This safety message means that you could be seriously hurt or
killed if you open the product and expose yourself to hazardous
voltage.
Hot surface.
This safety message means that some areas directly below are
hot and could burn you. Do not touch the hot areas.
CAUTION