Subaru LEGACY 2006 Manual page 4275

asieps_tobira.book 5 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM&H/U)
T
T
(1) VDC control module and hydraulic
control unit (VDCCM&H/U)
(2) Clip
(3) Bracket
(4) Rear RH outlet
C: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before disconnecting connectors of sensors or
units, be sure to disconnect the ground cable from
battery.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Vehicle components are extremely hot after driv-
ing. Be wary of receiving burns from heated parts.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
General Description
(10)
T
(3)
T
(5) Rear LH outlet
(6) Secondary inlet
(7) Primary inlet
(8) Front LH outlet
(9) Front RH outlet
VDC-5
VEHICLE DYNAMICS CONTROL (VDC)
(8) (7)
(6) (9)
(5)
(4)
(1)
(11)
(10) Pressure sensor
(11) Damper
Tightening torque: N·m (kgf-m, ft-lb)
T: 33 (3.4, 24)
(2)
VDC00197