Toyota Tundra 2005 Service - Repair - Maintenance page 2317

AUTOMATIC TRANSMISSION (A750E, A750F)
SST
SST
− EXTENSION HOUSING OIL SEAL (A750E)
EXTENSION HOUSING OIL SEAL
(A750E)
ON−VEHICLE REPAIR
1. DRAIN AUTOMATIC TRANSMISSION FLUID
(a) Remove the drain plug and gasket, and drain the ATF.
(b) Install a new gasket and the drain plug.
Torque: 20 N·m (204 kgf·cm, 15 ft·lbf)
D13867
2. REMOVE PROPELLER SHAFT (See page PR−3)
3. REMOVE REAR OIL SEAL
NOTICE:
Clean the extension housing before removing the oil seal.
Using SST, remove the oil seal.
SST
OR0004
4. INSTALL OIL SEAL
(a) Using SST and a hammer, carefully drive a new oil seal
in until it stops.
SST
(b) Coat the lip of the oil seal with MP grease.
5. INSTALL PROPELLER SHAFT (See page PR−8)
6. FILL TRANSMISSION (See page AT−4)
OR0005
09308−10010
09325−40010
AT−7
AT13L−01