Ip Ospf Hello-Interval - Dell S6100 Configuration Manual

ip ospf hello-interval

Specify the time interval between the hello packets sent on the interface.
Syntax ip ospf hello-interval seconds
To return to the default value, use the no ip ospf hello-interval command.
Parameters
seconds
Defaults 10 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
pre- 6.1.1.1
Usage Information The time interval between the hello packets must be the same for routers in a network.
Related Commands
•
Enter the number of seconds for the interval. The range is from 1 to 65535. The default is
10 seconds.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
ip ospf dead-interval — set the time interval before a router is declared dead.
Open Shortest Path First (OSPFv2 and OSPFv3) 1093