Ip Ospf Cost - Dell S6100 Configuration Manual

ip ospf cost

Change the cost associated with the OSPF traffic on an interface.
Syntax ip ospf cost cost
To return to default value, use the no ip ospf cost command.
Parameters
cost
Defaults The default cost is based on the reference bandwidth.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
pre- 6.1.1.1
Usage Information
If this command is not configured, cost is based on the auto-cost command.
When you configure OSPF over multiple vendors, to ensure that all routers use the same cost, use the ip ospf
cost command. Otherwise, OSPF routes improperly.
Related Commands
•
Enter a number as the cost. The range is from 1 to 65535.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
auto-cost — control how the OSPF interface cost is calculated.
Open Shortest Path First (OSPFv2 and OSPFv3) 1091