Passive-Interface - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
7.5.1.0
pre- 6.1.1.1
Usage Information
To enable OSPF on an interface, the network area command must include, in its range of addresses, the
primary IP address of an interface.
If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area
0.

passive-interface

Suppress both receiving and sending routing updates on an interface.
Syntax passive-interface {default | interface}
To enable both the receiving and sending routing, use the no passive-interface interface command.
To return all OSPF interfaces (current and future) to active, use the no passive-interface default
command.
Parameters
default
interface
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced to all platforms.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: An interface can be attached only to a single OSPF area.
Enter the keyword default to make all OSPF interfaces (current and future) passive.
Enter the following keywords and slot/port or number information:
Open Shortest Path First (OSPFv2 and OSPFv3) 1103