Dell S6100 Configuration Manual page 1136

Parameters
process-id
vrf vrf-name
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.1
Usage Information The following describes the show ip ospf process-id neighbor command shown in the following
example.
Item
Neighbor ID
Pri
State
Dead Time
Address
Interface
Area
Example
Dell# show ip ospf 34 neighbor
Neighbor ID Pri State
20.20.20.7
192.10.10.2 1 FULL/DR
1136 Open Shortest Path First (OSPFv2 and OSPFv3)
Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
Enter the keyword vrf followed by the name of the VRF to show information
corresponding to the OSPF neighbors that are tied to a specific VRF.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000..
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the neighbor router ID.
Displays the priority assigned neighbor.
Displays the OSPF state of the neighbor.
Displays the expected time until the Dell OS declares the neighbor dead.
Displays the IP address of the neighbor.
Displays the interface type slot/port information.
Displays the neighbor's area (process ID).
Dead Time Address
1 FULL/DR 00:00:32 182.10.10.3 Te 1/1/1/1 0.0.0.2
00:00:37 192.10.10.2 Te 1/1/2/1 0.0.0.1
Interface Area