ip igmp last-member-query-interval
Use the ip igmp last-member-query-interval command in Interface Configuration mode to
configure the Maximum Response Time inserted in Group-Specific Queries which are sent in
response to Leave Group messages.
Syntax
ip igmp last-member-query-interval
no ip igmp last-member-query-interval
tenthsofseconds — Maximum Response Time in tenths of a second (Range: 0-255)
•
Default Configuration
The default Maximum Response Time value is ten (in tenths of a second).
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures 2 seconds as the Maximum Response Time inserted in VLAN
15's Group-Specific Queries.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp last-member-query-interval 20
ip igmp query-interval
Use the ip igmp query-interval command in Interface Configuration mode to configure the
query interval for the specified interface. The query interval determines how fast IGMP Host-
Query packets are transmitted on this interface.
Syntax
ip igmp query-interval
no ip igmp query-interval
seconds — Query interval. (Range: 1-3600)
•
tenthsofseconds
seconds
589
IGMP Commands