Ip Igmp Last-Member-Query-Interval - Dell C9000 Series Reference Manual

ip igmp last-member-query-interval

Change the last member query interval, which is the Max Response Time inserted into Group-Specific
Queries sent in response to Leave Group messages. This interval is also the interval between Group-Specific
Query messages.
C9000 Series
Syntax
ip igmp last-member-query-interval milliseconds
To return to the default value, use the no ip igmp last-member-query-interval
command.
Parameters
milliseconds
Defaults 1000 milliseconds
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
Enter the number of milliseconds as the interval. For IGMP
version 2, the range is from 100 to 25599. For IGMP version 3,
the range is from 100 to 65535. The default value is 1000
milliseconds.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON. For IGMP version 2, the Interval
range is modified.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Internet Group Management Protocol (IGMP) 1130