Dell S6100 Configuration Manual page 1075

Field
l:
rid:
aid:
chk:
aut:
auk:
keyid:
to:
dst:
netmask:
pri:
N, MC, E, T
hi:
di:
dr:
bdr:
Example
Dell# debug ip ospf 1 packet
OSPF process 90, packet debugging is on
Description
• 1 - Hello packet
• 2 - database description
• 3 - link state request
• 4 - link state update
• 5 - link state acknowledgement
Displays the packet length.
Displays the OSPF router ID.
Displays the Autonomous System ID.
Displays the OSPF checksum.
States if OSPF authentication is configured. One of the following is listed:
• 0 - no authentication configured
• 1 - simple authentication configured using the ip ospf authentication-key
command
• 2 - MD5 authentication configured using the ip ospf message-digest-key
command
If the ip ospf authentication-key command is configured, this field displays the
key used.
If the ip ospf message-digest-key command is configured, this field displays the
MD5 key
Displays the interface to which the packet is intended.
Displays the destination IP address.
Displays the destination IP address mask.
Displays the OSPF priority
Displays information available in the Options field of the HELLO packet:
• N + (N-bit is set)
• N - (N-bit is not set)
• MC+ (bit used by MOSPF is set and router is able to forward IP multicast packets)
• MC- (bit used by MOSPF is not set and router cannot forward IP multicast packets)
• E + (router is able to accept AS External LSAs)
• E - (router cannot accept AS External LSAs)
• T + (router can support TOS)
• T - (router cannot support TOS)
Displays the amount of time configured for the HELLO interval.
Displays the amount of time configured for the DEAD interval.
Displays the IP address of the designated router.
Displays the IP address of the Border Area Router.
Open Shortest Path First (OSPFv2 and OSPFv3) 1075