Show Ip Ospf Statistics - Dell S6100 Configuration Manual

This command has the following limitations:
•
•
Example
Dell# show ip ospf 100 route
Prefix
1.1.1.1
3.3.3.3
13.0.0.0
150.150.150.0
172.30.1.0
Dell#

show ip ospf statistics

Display OSPF statistics.
Syntax show ip ospf [process-id | vrf vrf-name] statistics global | [interface name
{neighbor router-id}]
Parameters
process-id
vrf vrf-name
global
interface name
1138 Open Shortest Path First (OSPFv2 and OSPFv3)
The display output is sorted by prefixes; intra-area ECMP routes are not displayed together.
For Type 2 external routes, Type 1 cost is not displayed.
NOTE: Starting with Version 9.4(0.0), the loopback IP address advertised to the neighbor is not
displayed in the output because they are not accounted as inactive OSPF routes, whereas the loopback
IP address is displayed until Dell Networking OS Version 9.3(0.0). Starting with Version 9.4(0.0), the
show ip ospf routes command displays the interface and area ID information of connected networks in
addition to the other settings, whereas these details are not displayed until Dell Networking OS Version
9.3(0.0). Starting with Version 9.4(0.0), the metric of E2 routes in the output is displayed as an external
metric, whereas until Dell Networking OS Version 9.3(0.0), the number of hops to the ASBR for E2
routes are displayed in the output.
Cost Nexthop
1 0.0.0.0
2 13.0.0.3
1 0.0.0.0
2 13.0.0.3
2 13.0.0.3
Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
Enter the keyword vrf followed by the name of the VRF to display statistics
corresponding to the OSPF process that is tied to a specific VRF.
Enter the keyword global to display the packet counts received on all running OSPF
interfaces and packet counts OSPF neighbors receive and transmit.
(OPTIONAL) Enter the keyword interface then one of the following interface
keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
Interface Area Type
Lo 0 0 Intra-Area
Te 1/1/4/1 1 Intra-Area
Te 1/1/4/1 0 Intra-Area
Te 1/1/4/1 - External
Te 1/1/4/1 1 Intra-Area