Track Interface Line-Protocol - Dell S6100 Configuration Manual

Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
8.3.12.0
8.4.1.0
Usage Information Use this command to create an object that tracks the routing state of an IPv4 Layer 2 interface:
•
•
Related Commands
•
•

track interface line-protocol

Configure object tracking on the line-protocol state of a Layer 2 interface.
Syntax track object-id interface interface line-protocol
To return to the default setting, use the no track object-id command.
Parameters
object-id
interface
Defaults None
Command Modes CONFIGURATION
1054 Object Tracking
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON. Added support for tunnel interface.
Introduced on the S4810.
Introduced.
The status of the IPv4 interface is UP only if the Layer 2 status of the interface is UP and the interface has a
valid IP address.
The Layer 3 status of an IPv4 interface goes DOWN when its Layer 2 status goes down (for a Layer 3 VLAN,
all VLAN ports must be down) or the IP address is removed from the routing table.
show track – display information about tracked objects, including configuration, current state, and clients which
track the object.
track interface line-protocol
Enter the ID number of the tracked object. The range is 1 to 500.
Enter one of the following values:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a tunnel interface, enter the keyword tunnel.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
– configure object tracking on the line-protocol state of a Layer 2 interface.