Area Default-Cost - Dell S6100 Configuration Manual

Open Shortest Path First (OSPFv2 and OSPFv3)
Open Shortest Path First version 2 for IPv4 is supported on platform.
OSPF is an interior gateway protocol (IGP), which means that it distributes routing information between routers in a single autonomous
system (AS). OSPF is also a link-state protocol in which all routers contain forwarding tables derived from information about their links to
their neighbors.
The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on) are the same for OSPFv2 and
OSPFv3. OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis.
The Dell Networking OS versions 9.4(0.0) and 9.7(0.0) introduce support for VRF on OSPFv2 and OSPFv3 respectively. The multi-process
OSPF feature supported on Dell Networking OS version 7.8.1.0 is modified. In earlier versions, multiple OSPF processes were created
without VRF (prior to 9.4(0.0)). In the Dell Networking OS versions 9.4(0.0) and 9.7(0.0) (for OSPFv3), multiple OSPF processes can be
created on a router, but with only one OSPF process per VRF. However, there can be one OSFPv2 and one OSPFv3 on the same VRF.
This section is divided into two sections. There is no overlap between the two sets of commands. You cannot use an OSPFv2 command in
the IPv6 OSPFv3 mode. OSPFv2 is supported on IPv4 tunnels only and OSPFv3 is supported on IPv6 tunnels only.
Topics:
• OSPFv2 Commands
• OSPFv3 Commands
OSPFv2 Commands
The Dell Networking implementation of OSPFv2 is based on IETF RFC 2328. .

area default-cost

Set the metric for the summary default route the area border router (ABR) generates into the stub area. Use this command on the border
routers at the edge of a stub area.
Syntax area area-id default-cost cost
To return default values, use the no area area-id default-cost command.
Parameters
area-id
cost
1066 Open Shortest Path First (OSPFv2 and OSPFv3)
Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a number from zero
(0) to 65535.
Specifies the stub area's advertised external route metric. The range is from zero (0) to
65535.
36