Canon imageRUNNER ADVANCE 6075 Series Service Manual page 142

2
Technology > Image Formation System > Servicing > When Replacing Parts
● Drum
<Procedure of parts replacement>
see "Removing the Photosensitive Drum," on p. 4-122.
<Procedure of adjustment>
1) Clear the parts counter. (COPIER>COUNTER>LF>K-DRM-LF)
2) Replace the ROM connected to the host machine with the drum ROM included in the drum.
NOTE:
If the ROM is not replaced, the replaced drum and the drum-unique data stored
in the ROM data are not matched. As a result, when the 2D shading function is
enabled, it is not functioned normally.
2-1) Remove the Drum EEROM.
• 1 Screw
• 1 Connector
2 Technology > Image Formation System > Servicing > When Replacing Parts
3) Affix the ID Label included in the drum to the inside of the Front Cover.
4) Activate the drum replacement mode. (COPIER>FUNCTION>INSTALL>DRM-INIT)
5) Check the 2-dimensional shading ROM. (COPIER>FUNCTION>2D-SHADE>2D-READ)
F-2-110
2-88
F-2-111
2-88