Procedure After Replacing The Adf Unit; Pickup Feed Unit; Removing The Adf Pickup Feed Unit - Canon iR C1020 Series Service Manual

Chapter 6
[2]
6) Close the ADF upper cover [1].
[1]
7) Remove the ADF unit communication cable [1].
- 1 screw [2]
- 1 connector [3]
- 1 wire saddle [4]
8) Open the ADF unit [1].
6-8
[3]
[1]
F-6-17
F-6-18
[1] [3]
[2] [4]
F-6-19
9) Remove the ADF unit [1].

6.4.1.2 Procedure after Replacing the ADF Unit

After replacing the ADF unit, execute automatic detection of the CCD read-
ing position at ADF stream reading in the following service mode.
COPIER> FUNCTION> INSTALL> STRD-POS
[Operation]
Adjust the reading position by moving the scanner in increments of 0.1
mm.
[Time]
When the lamp is turned on: Adjustment time; 10 seconds
When the lamp is not turned on: Lamp adjustment time; 10 to 30 seconds
+ Adjustment time; 10 seconds

6.4.2 Pickup Feed Unit

6.4.2.1 Removing the ADF Pickup Feed Unit

1) Open the ADF upper cover [1].
[1]
F-6-20
[1]
F-6-21
0021-0352
0019-5863