Rep 5.9 Dadh Tray Size Sensors; Rep 5.10 Registration Sensor - Xerox ColorQube 9303 Series Service Manual

REP 5.9 DADH Tray Size Sensors

Parts List on PL 5.35
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the input tray assembly, REP
Disconnect the ground harness from the static eliminator before the input tray assembly lower
cover is removed, refer to Figure 1.
2. Turn the input tray assembly upside down, then remove the Lower cover right,
Item 9.
3. Remove the relevant sensor, Figure
1
Remove the ground harness
and bracket.
Sensor 2.
Sensor 1.
Figure 1 Tray size sensors
Replacement
The replacement is the reverse of the removal procedure.
ColorQube® 9303 Family
WARNING
GP 14. Disconnect the power cord
5.4.
CAUTION
1.
Ground harness.
See CAUTION.
2
Disconnect the correct PJ. Remove
the correct sensor.

REP 5.10 Registration Sensor

Parts List on PL 5.25
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the DADH, top cover assembly,
2. Remove the registration sensor,
PL 5.35
1
Remove 2 screws.
February 2013
4-47
WARNING
GP 14. Disconnect the power cord
REP 5.1.
Figure 1.
5
Disconnect PJ192. Remove
the registration sensor
4
Remove the sensor assembly.
3
2
Remove the pre-scan
Carefully release the
idler roll.
torsion spring.
Figure 1 Registration sensor
REP 5.9, REP 5.10
Repairs/Adjustments