Pfc Commands - Dell Z9500 Command Reference Manual

Version
9.7(0.0)
Usage
By default, iSCSI is enabled on the unit and the flow control is enabled on all of the
Information
interfaces. It is also acts as defaults when the link-level flow control is enabled on
one or more interfaces. To enable DCB, do one of the following:
•
•

PFC Commands

The following PFC commands are supported on the Z9500 platform.
clear pfc counters
Clear the PFC TLV counters and PFC statistics on an interface or linecard.
Syntax
clear pfc counters [port-type slot/port | linecard {unit number
| all } all backplane all}]
Parameters
port-type
linecard unit
number
all backplane
all
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Data Center Bridging (DCB)
Description
Introduced on the Z9500.
Apply the dcb-map command with the no pfc-mode command on to all the
interfaces.
Disable flow-control on all of the interfaces.
Enter the keywords port-type then the slot/port
information.
Enter the keyword linecard to clear the linecard number.
Enter the keywords all backplane all to clear the
counters on all interfaces.
Description
Introduced on the Z9500.
607