Ets Commands - Dell Z9500 Command Reference Manual

ETS Commands

dcb-enable
Enable data center bridging.
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues
Defaults The default is 2
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Usage
By default, iSCSI is enabled on the unit and the flow control is enabled on all of the
Information
interfaces. It is also acts as defaults when the link-level flow control is enabled on
one or more interfaces. To enable DCB, do one of the following:
•
•
clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port
Parameters
port-type
Defaults none
Command EXEC Privilege
Modes
614
Enter the pfc-queue range. To disable DCB, use the no dcb
enable command. The range is from 1 to 4.
Description
Introduced on the Z9500.
Apply the dcb-map command with the no pfc-mode command on to all the
interfaces.
Disable flow-control on all of the interfaces.
Enter the keywords port-type then the slot/port
information.
Data Center Bridging (DCB)