Max-Lsp-Lifetime - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Usage Information To configure the number of area addresses on router, use this command. This value

must be consistent with routers in the same area, otherwise the router forms only Level

2 adjacencies. The value must be same among all the routers to form Level 1

adjacencies.

max-lsp-lifetime

Set the maximum time that link-state packets (LSPs) exist without being refreshed.

C9000 Series

max-lsp-lifetime seconds

To restore the default time, use the no max-lsp-lifetime command.

1200 seconds

Command Modes

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Introduced on the Z9000.

Added support for LSP Throttling Enhancement.

The maximum lifetime of LSP in seconds. This value must be

greater than the lsp-refresh-interval command. The

higher the value the longer the LSPs are kept. The range is from

1 to 65535. The default is 1200.

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Intermediate System to Intermediate System (IS-IS)

Table of Contents