Lsp-Refresh-Interval - Dell C9000 Series Reference Manual

Because each device can generate a maximum of 255 LSPs, consider carefully whether
you use the lsp-mtu command.

lsp-refresh-interval

Set the link state PDU (LSP) refresh interval. LSPs must be refreshed before they expire. When the LSPs are not
refreshed after a refresh interval, they are kept in a database until their max-lsp-lifetime reaches zero and
then LSPs is purged.
C9000 Series
Syntax
lsp-refresh-interval seconds
To restore the default refresh interval, use the no lsp-refresh-interval
command.
Parameters
seconds
Defaults 900 seconds
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
The LSP refresh interval, in seconds. This value must be 300
seconds less than the value specified in the max-lsp-lifetime
command. The range is from 1 to 65535 seconds. The default is
900.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Intermediate System to Intermediate System (IS-IS) 1090