Table of Contents
Advertisement
To create route map instances, use these commands. There is no limit to the number of match commands
per route map, but the convention is to keep the number of match filters in a route map low. Set commands
do not require a corresponding match command.
Configuring Set Conditions
To configure a set condition, use the following commands.
•
Add an AS-PATH number to the beginning of the AS-PATH.
CONFIG-ROUTE-MAP mode
set as-path prepend as-number [... as-number]
•
Generate a tag to be added to redistributed routes.
CONFIG-ROUTE-MAP mode
set automatic-tag
•
Specify an OSPF area or ISIS level for redistributed routes.
CONFIG-ROUTE-MAP mode
set level {backbone | level-1 | level-1-2 | level-2 | stub-area}
•
Specify a value for the BGP route's LOCAL_PREF attribute.
CONFIG-ROUTE-MAP mode
set local-preference value
•
Specify a value for redistributed routes.
CONFIG-ROUTE-MAP mode
set metric {+ | - | metric-value}
•
Specify an OSPF or ISIS type for redistributed routes.
CONFIG-ROUTE-MAP mode
set metric-type {external | internal | type-1 | type-2}
•
Assign an IP address as the route's next hop.
CONFIG-ROUTE-MAP mode
set next-hop ip-address
•
Assign an IPv6 address as the route's next hop.
CONFIG-ROUTE-MAP mode
set ipv6 next-hop ip-address
•
Assign an ORIGIN attribute.
CONFIG-ROUTE-MAP mode
set origin {egp | igp | incomplete}
•
Specify a tag for the redistributed routes.
CONFIG-ROUTE-MAP mode
set tag tag-value
Access Control Lists (ACLs)
146
Advertisement
Table of Contents
Troubleshooting
