Neighbor Maximum-Prefix - Dell S6000 Reference Manual

no prepend
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
If a local-as is configured, BGP does not allow for the configuration of BGP
Information
confederation. Similarly, if BGP confederation is configured, then BGP does not
allow the configuration of local-as.
This command automatically restarts the neighbor session for the configuration to
take effect.
Related bgp four-octet-as-support
Commands

neighbor maximum-prefix

Control the number of network prefixes received.
S6000
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum
[threshold] [warning-only]
To return to the default values, use the no neighbor {ip-address | peer-
group-name} maximum-prefix maximum command.
Parameters
ip-address
peer-group-
name
Border Gateway Protocol
Specifies that local AS values do not prepend to
announcements from the neighbor.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— enables 4-byte support for the BGP process.
Enter the IP address of the neighbor in dotted decimal
format.
Enter the name of the peer group.
371