Permit - Dell MXL 10GbE Reference Manual

permit

To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or
UDP.
Syntax
permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} [count
[byte]] [dscp value] [order] [fragments] [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
•
•
Parameters
ip-protocol-
number
icmp
ipv6
tcp
udp
count
byte
dscp
order
fragments
log
threshold-in-
msgs
276
Use the no seq sequence-number command syntax if you know the filter's
sequence number
Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp |
udp} command
Enter an IPv6 protocol number. The range is from 0 to 255.
Enter the keyword icmp to filter internet Control Message
Protocol version 6.
Enter the keyword ipv6 to filter any internet Protocol
version 6.
Enter the keyword tcp to filter the Transmission Control
protocol.
Enter the keyword udp to filter the User Datagram Protocol.
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
Enter the keyword fragments to use ACLs to control packet
fragments.
OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
Access Control Lists (ACL)