Auto-Execute Command - 3Com S7906E Command Reference Manual

After you specify to perform local password authentication, when a user logs in through the Console
port, a user can log into the switch even if the password is not configured on the switch. But for a VTY
user interface, a password is needed for a user to log into the switch through it under the same
condition.
By default, users logging in through the Console port are not authenticated, whereas modem users and
Telnet users are authenticated.
For VTY user interface, if you want to set the login authentication mode to none or password, you must
first verify that the SSH protocol is not supported by the user interface. Otherwise, your configuration
will fail. Refer to
Examples
# Configure to authenticate users using the local password.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] authentication-mode password

auto-execute command

Syntax
auto-execute command text
undo auto-execute command
View
User interface view
Default Level
3: Manage level
Parameters
text: Command to be executed automatically.
Description
Use the auto-execute command command to set the command that is executed automatically after a
user logs in.
Use the undo auto-execute command command to disable the specified command from being
automatically executed.
Use these two commands in the VTY user interface only.
Normally, the telnet command is specified to be executed automatically to enable the user to Telnet to a
specific network device automatically.
protocol inbound.
1-3