Honda Accord 2008 Manual page 622

Hide thumbs Also See for Accord 2008:
Table of Contents

Advertisement

07/11/02 09:15:18 61TA0000_110_0303
9. Turn the ignition switch to ON (II).
10. Measure voltage between rocker arm oil pressure
switch 2P connector terminal No. 1 and body
ground.
02
ROCKER ARM OIL PRESSURE SWITCH 2P CONNECTOR
Is there battery voltage?
YES
arm oil pressure switch and G101 (see page 22-20),
then go to step 15.
NO
Go to step 11.
11. Turn the ignition switch to LOCK (0).
12. Jump the SCS line with the HDS.
13. Disconnect ECM/PCM connector C (49P).
VTPSW (BLU/BLK)
Wire side of female terminals
Repair open in the wire between the rocker
14. Check for continuity between rocker arm oil
pressure switch 2P connector terminal No. 1 and
ECM/PCM connector terminal C22.
ROCKER ARM OIL PRESSURE SWITCH 2P CONNECTOR
VTPSW (BLU/BLK)
Terminal side of female terminals
ECM/PCM CONNECTOR C (49P)
VTPSW (BLU/BLK)
Terminal side of female terminals
Is there continuity?
YES
Go to step 22.
NO
Repair open in the wire between the ECM/
PCM (C22) and the rocker arm oil pressure switch,
then go to step 22.
15. Turn the ignition switch to LOCK (0).
16. Reconnect all connectors.
17. Turn the ignition switch to ON (II).
18. Reset the ECM/PCM with the HDS.
19. Do the ECM/PCM idle learn procedure (see page
11-343).
03
(cont'd)
11-303

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents