Honda Accord 2008 Manual page 614

07/11/02 09:14:26 61TA0000_110_0295
14. Check the oil pressure.
Does the oil pressure increase to at least 392 kPa
( 4.0 kgf / cm , 56.9 psi)?
YES
(see page 11-329), then go to step 19.
−
NO
the rocker arm oil control valve (see page 11-327),
then go to step 19.
15. Turn the ignition switch to LOCK (0).
16. Jump the SCS line with the HDS.
17. Disconnect ECM/PCM connector C (49P).
18. Check for continuity between ECM/PCM connector
terminal C22 and body ground.
＊０２
Is there continuity?
YES
PCM (C22) and the rocker arm oil pressure switch,
then go to step 19.
NO −
2
− Replace the rocker arm oil pressure switch
Inspect the VTEC system. If it is OK, replace
ECM/PCM CONNECTOR C (49P)
VTPSW (BLU/BLK)
Terminal side of female terminals
− Repair short in the wire between the ECM/
Go to step 25.
19. Reconnect all connectors.
20. Turn the ignition switch to ON (II).
21. Reset the ECM/PCM with the HDS.
22. Do the ECM/PCM idle learn procedure (see page
11-343).
23. Do the VTEC TEST in the INSPECTION MENU with
the HDS.
24. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P2646 indicated?
YES − Check for poor connections or loose
terminals at the rocker arm oil pressure switch, the
rocker arm oil control solenoid and the ECM/PCM,
then go step 1.
−
NO Troubleshooting is complete. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated DTC's troubleshooting.
25. Reconnect all connectors.
(cont'd)
11-295