Subaru IMPREZA GD 2007 Series Manual page 3756

asieps_tobira_IM_US.book 15 ページ ２０１２年１月１７日 火曜日 午後３時４８分
4. Front Door
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the front door trim. <Ref. to EI-41, RE-
MOVAL, Front Door Trim.>
3) Remove the outer mirror assembly. <Ref. to
GW-18, REMOVAL, Outer Mirror Assembly.>
4) Remove the front door glass. <Ref. to GW-11,
REMOVAL, Front Door Glass.>
5) Remove the front door regulator and motor.
<Ref. to GW-15, REMOVAL, Front Regulator and
Motor Assembly.>
6) Remove the front door latch assembly. <Ref. to
SL-31, REMOVAL, Front Door Latch and Door
Lock Actuator Assembly.>
7) Remove the front outer handle. <Ref. to SL-30,
REMOVAL, Front Outer Handle.>
8) Remove the front pillar lower trim to disconnect
connector from the body harness.
9) Put a wooden block on jack and place jack under
the front door. Support the door with a jack to pro-
tect it from damage.
NOTE:
When supporting with jack, do not deform the hinge
portion of door during work.
Front Door
10) Remove the checker bolts.
11) Remove the door-side bolts for upper and low-
er hinges to remove front door panel.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Apply grease to the moving part of door hinges.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
EB-00012
tion". <Ref. to EB-7, FRONT FENDER PANEL,
COMPONENT, General Description.>
C: ADJUSTMENT
1) Using the ST, loosen the body-side bolts of up-
per and lower hinges to align the position for verti-
cal and horizontal direction of the front door panel.
ST 925610000
EB-00013
EB-15
EXTERIOR BODY PANELS
EB-00014
EB-00015
WRENCH
ST
EB-00016