Subaru IMPREZA GD 2007 Series Manual page 3759

asieps_tobira_IM_US.book 18 ページ ２０１２年１月１７日 火曜日 午後３時４８分
EXTERIOR BODY PANELS
6. Rear Door
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the rear door trim. <Ref. to EI-42, RE-
MOVAL, Rear Door Trim.>
3) Remove the rear door glass. <Ref. to GW-21,
REMOVAL, Rear Door Glass.>
4) Remove the rear door regulator and motor as-
sembly. <Ref. to GW-23, REMOVAL, Rear Regula-
tor and Motor Assembly.>
5) Remove the rear door latch. <Ref. to SL-35, RE-
MOVAL, Rear Door Latch and Door Lock Actuator
Assembly.>
6) Remove the rear outer handle. <Ref. to SL-34,
REMOVAL, Rear Outer Handle.>
7) Remove the connection of rubber dust (A) from
center pillar, pull out the connection of door har-
ness to separate.
(A)
8) Put a wooden block on jack and place jack under
the rear door. Support the rear door with jack to
protect it.
NOTE:
When supporting with jack, do not deform the hinge
portion of door during work.
Rear Door
9) Remove the checker bolts.
10) Remove the door-side bolts for upper and low-
er hinges to remove the rear door panel.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Apply grease to the moving part of door hinges.
Tightening torque:
EB-00239
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to EB-9, REAR DOOR PANEL,
COMPONENT, General Description.>
EB-00013
EB-18
EB-00014
EB-00015