Dell S6100 Configuration Manual page 1325

connected
isis
ospf
static
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
7.8.1.0
7.6.1.0
pre- 6.2.1.1
Related Commands
•
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
(OPTIONAL) Enter the keyword connected to filter only directly connected routes.
(OPTIONAL) Enter the keyword isis to filter only IS-IS routes.
(OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
(OPTIONAL) Enter the keyword static to filter manually configured routes.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on the E-Series.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.
Routing Information Protocol (RIP) 1325