Erpm - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.5(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.7.1.0
7.5.1.0
pre-7.7.1.0
Related Commands
•

erpm

Configure the source and destination IP address for ERPM traffic.
Syntax erpm source-ip ip-address dest-ip ip-address [gre-protocol value]
To remove the configuration, use the no erpm source-ip IP-address dest-ip IP-address [gre-
protocol value] command.
Parameters
source–ip ip-
address
destination–ip ip-
address
gre–protocol value
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Example
Dell(conf-mon-sess-10)#erpm source-ip 10.10.10.1 dest-ip 5.1.1.2 gre-protocol
1111
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
monitor session — enables a monitoring session.
Enter the keywords source-ip then the source IP address in dotted decimal format.
Enter the keywords dest-ip then the destination IP address in dotted decimal format.
(OPTIONAL) Enter the keywords gre-protocol then the protocol type value for
ERPM type monitor session. The range is from 1 to 65535.
Port Monitoring 1225