Ipv6 Ospf Area - Dell S6100 Configuration Manual

Parameters
planned-only
unplanned-only
Defaults OSPFv3 graceful restart supports both planned and unplanned failures.
Command Modes ROUTER OSPFv3
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
9.1.(0.0)
8.4.2.2
8.3.19.0
Usage Information
OSPFv3 graceful restart supports planned-only and/or unplanned-only restarts. The default is support for both
planned and unplanned restarts.
•
•
By default, both planned and unplanned restarts trigger an OSPFv3 graceful restart. Selecting one or the other
mode restricts OSPFv3 to the single selected mode.

ipv6 ospf area

Enable IPv6 OSPF on an interface.
Syntax ipv6 ospf process id areaarea id
To disable OSPFv6 routing for an interface, use the no ipv6 ospf process-id area area-id command.
Parameters
process-id
1160 Open Shortest Path First (OSPFv2 and OSPFv3)
(OPTIONAL) Enter the keywords planned-only to indicate graceful restart is
supported in a planned restart condition only.
(OPTIONAL) Enter the keywords unplanned-only to indicate graceful restart is
supported in an unplanned restart condition only.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the S4810 and Z9000.
Introduced on the E-Series.
Introduced on the S4820T.
A planned restart occurs when you enter the redundancy force-failover rpm command to force the
primary RPM to switch to the backup RPM. During a planned restart, OSPF sends out a Type-11 Grace LSA
before the system switches over to the backup RPM.
An unplanned restart occurs when an unplanned event causes the active RPM to switch to the backup RPM,
such as when an active process crashes, the active RPM is removed, or a power failure happens. During an
unplanned restart, OSPF sends out a Grace LSA when the backup RPM comes online.
Enter the process identification number.