Show Config - Dell S6100 Configuration Manual

Version
8.3.7.0
7.8.1.0
7.6.1.0
pre- 6.2.1.1
Usage Information To enable RIP, assign a network address using the network command.
Example
Dell(conf)# router rip
Dell(conf-router_rip)#
Related Commands
•
•

show config

Display the changes you made to the RIP configuration. The default values are not shown.
Syntax show config
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
pre- 6.2.1.1
1340 Routing Information Protocol (RIP)
Description
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
network — enables RIP.
exit — returns to CONFIGURATION mode.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.