Distribute-List Out - Dell S6100 Configuration Manual

Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.29.0
8.3.11.1
8.5.1.0
8.3.7.0
7.8.1.0
7.6.1.0
pre- 6.2.1.1
Related Commands
•

distribute-list out

Configure a filter for outgoing routing updates.
Syntax distribute-list prefix-list-name out [interface | bgp | connected | isis |ospf
| static]
To delete the filter, use the no distribute-list prefix-list-name out command.
Parameters
prefix-list-name
interface
1324 Routing Information Protocol (RIP)
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.
Enter the name of a configured prefix list.
(OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.