Service-Class Dynamic Dot1P - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.6.1.0
6.1.1.1
Usage Information
If traffic is shaped between 64 and 1000 Kbs, for some values, the shaped rate is much less than the value
configured.
On 40-port 10G stack-unit if the traffic is shaped between 64 and 1000 Kbs, for some values, the shaped rate is
much less than the value configured.
Related Commands
•

service-class dynamic dot1p

Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
Syntax service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic dot1p command. The
default mapping is as follows:
1262 Quality of Service (QoS)
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the kbps option on the C-Series, E-Series, and S-Series.
Introduced on the S-Series and C-Series.
Introduced on the E-Series.
NOTE: When packets of size greater than 7000 bytes are expected to be received from the network,
Dell Networking recommends that you configure the burst value to be more than 175 KB if you
configured the rate shape. Such a setting ensures proper bandwidth sharing across queues.
rate-shape — shapes traffic output as part of the designated policy.