Dell S6100 Configuration Manual page 1216

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
8.1.1.0
7.8.1.0
Usage Information The following describes the show ip pim interface command shown in the following example.
Field
Address
Interface
Ver/Mode
Nbr Count
Query Intvl
DR Prio
DR
The show ip pim interface command does not display information corresponding to the loop-back
interfaces.
Example
Dell# show ip pim interface
Address
165.87.34.5
10.1.1.2
20.1.1.5
165.87.31.200
Dell#
1216 PIM-Sparse Mode (PIM-SM)
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series.
Introduced on the S-Series.
Description
Lists the IP addresses of the interfaces participating in PIM.
List the interface type, with either slot/port information or ID (VLAN or Port Channel), of
the interfaces participating in PIM.
Displays the PIM version number and mode for each interface participating in PIM:
• v2 = PIM version 2
• S = PIM Sparse mode
Displays the number of PIM neighbors discovered over this interface.
Displays the query interval for Router Query messages on that interface (configured with
ip pim query-interval command).
Displays the Designated Router priority value configured on the interface (use the ip
pim dr-priority command).
Displays the IP address of the Designated Router for that interface.
Interface Ver/
Mode
Te 1/1/1/1 v2/S
Vl 10 v2/S
Vl 20 v2/S
Vl 30 v2/S
Nbr Query DR
Count Intvl Prio
0 30 1
1 30 1
1 30 1
1 30 1
DR
165.87.34.5
10.1.1.2
20.1.1.5
165.87.31.201