Ip Pim Neighbor-Filter - Dell S6100 Configuration Manual

Version
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.7.1.0
Usage Information
When you configure a join filter, it is applicable for both ingress and egress flows. There is no option to specify in or
out parameters while configuring a join filter.
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Dell(config-if-te-1/1)# ip pim join-filter iptv-channels
Dell(config-if-te-1/1)# ip pim join-filter iptv-channels
Related Commands
•

ip pim neighbor-filter

To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
Syntax ip pim [vrf vrf-name] neighbor-filter {access-list}
To remove the restriction, use the no ip pim [vrf vrf-name] neighbor-filter {access-list}
command.
Parameters
vrf vrf-name
access-list
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series for the port-channels and the S-Series.
Introduced on the E-Series.
ip access-list extended — configure an access list based on IP addresses or protocols.
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to prevent that
VRF from participating in PIM.
NOTE:
VRF.
Enter the name of a standard access list. Maximum 16 characters.
Description
Introduced on the S6100-ON.
Applies to specific VRF if input is provided, else applies to default
PIM-Sparse Mode (PIM-SM) 1205